Samsung RF24FSEDBSR Using the doors, Removing The Freezer Accessories, Flex Zone, 26_ operating

To remove

• Simply lift the bin up and pull straight out.

2

• Tilt up the front of the drawer and pull straight out, and pull out the drawer after moving slightly in the direction of the arrow.

To re-install

•Insert the drawer into the frame rails and push back into place.

•Slide bin in above the desired location and push down until it stops.

The drawers need to be removed before CAUTION the glass shelf above them can be lifted

out.

5. Flex Zone

To remove the Flex Zone – Pull the Flex door out to full extension. Lift the Flex Zone up, pulling it to your body with both hands.

To re-install the Flex Zone – Open the Flex door to full extension. Tilt the front of the Flex Zone up, place the back of the Flex Zone onto the rails, and then lower the front until the whole Zone rests on the rails.

1

1.Refer to page 12 for disassembly instructions.

2.Open the cap cover rail with a flat-blade screwdriver.

Using the doors

Ensure that the doors close all the way and are securely sealed.

When the refrigerator door is only partially open, it will automatically close. If the the door is opened more than its auto close range, it will remain open. You must close it manually.

REMOVING THE FREEZER ACCESSORIES

1. Freezer Room Guard

To remove - Remove the freezer room guard ( 1 ) by lifting the guard up.

To re-install- Push down until the guard ( 1 ) locks into place.

1

When the Flex Zone or LED lighting is not working, check the connectors [ ( 1 ), ( 2 ) shown below ] for cracks or leaks.

26_ operating

2. Super Extended Drawer

To remove - Pull the drawer out to full extension. Tilt up the rear of the drawer and lift straight out.