Refrigerator
Plastic Tubing
Compression |
| (Assembled) |
Nut (1/4”) |
| |
| Compression | |
(Assembled) |
| |
| Fitting | |
|
| |
|
| (Assembled) |
Ferrule |
| Molded |
| end(Bulb) | |
(Not supplied) |
| |
|
| |
|
| Compression |
|
| nut (B) (1/4”) |
|
| (Not supplied) |
Copper tubing | or | Plastic tubing (B) |
(Not supplied) |
| (Not supplied) |
Household water supply line
111 Connect the household water line to the assembled compression fitting.
Do not use without the molded end (Bulb) cAuTION of the plastic tubing ( B ).
222 Tighten the compression nut ( B ) onto the compression fitting.
Do not
333 Turn water on and check for any leakage. If you find water drops or leakage in the connection areas, turn off the main water supply. Check the connections and, if necessary, tighten.
444 Flush 1 gallon of water through the filter before drinking or using the water from the refrigerator. (Flush approximately 6 minutes.) To flush, press a large glass or cup against the water dispenser lever. Fill the glass, empty it into the kitchen sink after it is filled, and then repeat.
555 After you turn on the refrigerator, let the ice maker make ice for 1 to 2 days. Over that period of time, throw out the first 1 or 2 buckets of ice the freezer makes to ensure all impurities have been removed from the water line.
Only connect the water line to a drinkable |
|
water source. |
|
If you have to repair or disassemble the water line, |
|
cut off 1/4“ of the plastic tubing to make sure you |
|
get a snug, | up |
|
Completing the set up
Now that you have your new refrigerator installed | 01setting |
|
| ||
By completing the following steps, your refrigerator |
| |
in place, you are ready to set up and enjoy the |
|
|
features and functions of the appliance. |
|
|
should be fully operational. |
|
|
|
| |
111 Make sure your refrigerator is in an appropriate |
|
|
location with reasonable clearance between it |
|
|
and the wall. Refer to installation instructions in |
|
|
this manual. |
|
|
222 Once the refrigerator is plugged in, make sure |
|
|
the interior light comes on when you open the |
|
|
doors. |
|
|
333 Set the Temperature control to the coldest |
|
|
temperature and wait for an hour. The freezer |
|
|
will get slightly chilled and the motor will run |
|
|
smoothly. Reset the refrigerator and freezer to |
|
|
the temperatures you want. |
|
|
444 After you plug the refrigerator in, it will |
|
|
take a few hours to reach the appropriate |
|
|
temperature. You can store food and drinks |
|
|
in the refrigerator after the temperature is |
|
|
sufficiently cool. |
|
|
setting up _11
2012.3.31 9:49:44AM