Samsung RF4289HAR user manual Reattaching Refrigerator Doors, Disassemble the Flex Door

Disassemble the refrigerator doors

Be careful not to drop and scratch the WARNING doors while removing the doors.

1.With the door opened, remove the cap top table ( 1 ) with a flat-blade screwdriver (-), and then close the door.

Remove the 3 screws holding down the top table ( 2 ) and turn it with several wires connected.

2

1

2.Disconnect one connector ( 3 ) on the right side door and one connector ( 4 ) on the left side door. Remove the water line ( 5 ) while pressing the dark gray part ( 6 ) of the water line coupler.

4

Red Clip	3
(1/4")

5

6

If a red clip is on the coupler, it must be CAUTION removed before removing the tube.

3.Remove the 3 hex head bolts ( 7 ) attached to the upper left and right door hinges with a socket wrench (10mm).

Remove the ground screw ( 8 ) attached to the upper left and right door hinges with a philips screwdriver (+). Remove the upper left and right door hinges ( 9 ).

Socket wrench

8

7

9

08_ setting up

4.Lift the door straight up to remove.

5.Remove the screw ( 10 ) attached to the lower left and right door hinges with a philips screwdriver (+). Remove the 2 hex head bolts ( 11 ) attached to the lower left and right door hinges with an allen wrench (3/16”). Remove the lower left and right door hinges ( 12 ).

12

10

11

Allen wrench

REATTACHING THE

REFRIGERATOR DOORS

To reattach the fridge doors after you have moved the fridge to its final location, assemble parts in reverse order.

1.The Water Line must be fully inserted to the center of transparent coupler (Type A) or the Guide Lines (Type B) to prevent water leakage from the dispenser.

2.Insert the clip in the install pack and check that it holds the line firmly.

Type A	Type B
	Dispenser
Center of Transparent coupler	The Guide Lines
clip A (1/4”)	clip A (1/4”)
(6.35mm)
	(6.35mm)

DISASSEMBLE THE FLEX DOOR

1. Take out the Flex Zone

( 1 ) by lifting it up. 1

DA68-02520A-13.indb 8 2013. 12. 2.

�� 5:08