ADJUSTING THE FREEZER DRAWER | INSTALLING THE WATER | |
LEVEL | DISPENSER LINE | |
|
|
|
Adjustment part | A water dispenser with a fi lter is one of the helpful |
| features on your new refrigerator. To help promote |
| better health, the water fi lter removes unwanted |
| particles from your water. However, it does not |
| sterilize or destroy microorganisms. You may need to |
| purchase a water purifying system to do that. |
| In order for the ice maker to operate properly, a water |
| pressure of 20~125 psi is required. |
Freezer Drawer | Under normal conditions, a 170 cc (5.75 oz.) cup can |
| be fi lled in about 10 seconds. |
1. Locate the | If the refrigerator is installed in an area with low water | |
pressure (below 20psi), you can install a booster pump | ||
Unscrew the 8 Phillips screws ( 2 ) slightly to loosen | ||
to compensate for the low pressure. | ||
the door. | ||
After you have connected the water line, make | ||
| ||
| sure the water storage tank inside the refrigerator is | |
| properly fi lled. To do this, press the water dispenser | |
1 | lever until the water runs from the water outlet. |
2
2. Loosen the controller screw ( 3 ) with a Phillips
01 SETTING UP
screwdriver (+).
3
3. Find the best level to align the door slope. | 2. | Locate the nearest cold water drinking line and | ||
• After adjustment, | ||||
| install the pipe |
| ||
tighten the |
| clamp and shut |
| |
controller screw |
| off valve. | Cold water line | |
and then the |
|
| Pipe clamp | |
philips screws. |
|
| ||
|
|
|
Example) The slope is about 0.08inch (2mm) as shown below. - Rotate the height adjuster to
Slope
Reference plane
setting up _09