ASSEMBLE THE FREEZER DRAWER
To reattach the drawer after you have moved the fridge to its fi nal location, assemble parts in reverse order.
ADJUSTING THE LEVEL
Make sure the refrigerator is level so that you can make fi nal adjustments. Use a level to test if the refrigerator is level both side to side and back to front. If the refrigerator is not level, it will not be possible
to get the doors perfectly even, which may cause moisture condensation and increased energy bills. Below is an example of how to level the refrigerator if the left side of the refrigerator is lower than the right side.
MAKING MINOR ADJUSTMENTS BETWEEN DOORS
Remember, a leveled refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator.
Adjustment
Fixed part part
How to adjust the level
1. Open the freezer drawer and remove the lower basket. (See to page 7)
2
The left door is fi xed. To make minor adjustments between doors, adjust only the right door.
2. Remove the two screws | 1 |
( 1 ) attached to the cover |
|
leg front ( 2 ) with a Philips |
|
screwdriver (+). |
|
3. Remove the cover leg front
( 2 ) by lifting the bottom part of the cover leg front up and pulling it out.
4.Insert a fl
1.Pull out the freezer drawer ( 1 ), then you can see the lower hinge ( 2 ).
2.Insert the supplied allen wrench(3/16”) ( 3 ) into the shaft ( 4 ) of the lower hinge.
3.Please adjust the height by turning the hex wrench ( 3 ) clockwise ( DOWN ) or
When you turn the hex wrench counter-
clockwise(), the door will move up.
2 |
|
3 | 3 |
4 |
|
1
Both control levers must be touching the fl oor
to avoid possible personal injury or property CAUTION damage because of tipping.
If the right side is lower, perform the same procedure, but with the right control lever.
It is diffi cult to remove the cover leg front from the refrigerator, so we do not recommend making small adjustments with the control lever. Instead, refer to the next page for the best way to make minor adjustments to the doors.
1.After adjusting the doors, insert the supplied fastener ( 6 ) using a pliers ( 5 ) in the gap between the
( 8 ). The number of fasteners you’ll need to insert depends on the gap.
2 fastener are enclosed with the refrigerator. The thickness of each fastener is 0.04”.
08_ setting up