Onkyo Connecting the Power/Turning on the DV-SP506, Adjusting the Display Brightness

Connecting the Power/Turning on the DV-SP506

Before connecting

•Make sure that all the connections on pages 18–28 are complete (the connection to a TV is required).

ON/STANDBY

STANDBY indicator

TOP MENU	URSOR	MENU
RETURN		SETUP
	P
	USH TO E

•For the above reasons, do not plug the DV-SP506 into a switched power sup- ply found on some amplifiers and AV receivers.

To a wall outlet

ON STANDBY

2

ON/STANDBY

STANDBY

Remote

controller

Press [ON/STANDBY] button on the DV-SP506 or [ON] on the remote controller.

Turn on your TV and select the input through which the DV-SP506 is connected.

The DV-SP506 turns on and the STANDBY indicator turns off.

•To put the DV-SP506 in the standby mode, press [ON/STANDBY] on the DV-SP506, or [STANDBY] on the remote controller.

•While the STANDBY indicator lights up, the DV-SP506 can receive signals from the remote controller.

•Setting the [ON/STANDBY] button to standby does not shut off the power completely.

1	Plug the supplied power cord into
	the AC INLET and then into the
	power outlet on the wall.

•Do not use a power cord other than the one supplied with the DV-SP506. The power cord supplied is designed for use with the DV-SP506 and should not be used with any other device.

•Never have the power cord discon- nected from the DV-SP506 while the other end is plugged into the wall out- let. Doing so may cause an electric shock. Always connect by plugging into the wall outlet last and disconnect by unplugging from the wall outlet first.

•Before unplugging the DV-SP506 from the power outlet, make sure you first switch it into standby.

Note:

•The DV-SP506 features a screen saver and an auto power off function. If the DV-SP506 is stopped and no button is pressed for 15 minutes, the screen saver starts (see page 56). If the disc tray is closed but no disc is playing and no control is pressed for 20 minutes, the DV-SP506 automatically goes into standby (see page 58).

Adjusting the Display Brightness

You can adjust the brightness of the display as follows.

1	Press the [DIMMER] button
	repeatedly to cycle through the
	following options:
	Dim, dimmer, or normal.

Note:

•When the display brightness is changed, the display brightness of other Onkyo AV components connected

via also changes. This does not work for compo- nents connected via RIHD.

29