Samsung RSG307AAWP, RSG307AABP Setting UP the Refrigerator Doors, Removing the freezer door

SETTING UP THE REFRIGERATOR DOORS

If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.

Separating the Water Supply Line from the Refrigerator

1.Pull the two water lines (which are in the Fixer) out to the front.

2.Removing the FIXER HINGE ,and next take off the upper hinge. Be careful that the door does not fall on you as you are removing it.

Be sure to keep track of all parts you are removing.

3.Next, remove the door from the lower hinge 5 by carefully lifting the door straight up 6 .

01 SETTING UP

2.Remove two water lines (White one is for water and the other one is for ice) by pressing the coupler 1 and pulling the water line 2 away.

1

Make sure the color of the water lines match.

2

Removing the freezer door

A few things to mention fi rst.

•Make sure that you lift the door straight up so the hinges are not bent or broken.

•Be careful not to pinch the water tubing and wire harness on the door.

•Place doors on a protected surface to prevent scratching or damage.

1.Remove a screw on the upper hinge cover 1 . With the door open, disengage the two locking tabs with a fl at-head screw driver 2 and remove it while the lifting up the rear of the cover 3 , and then disconnect the wires by gently pulling them apart 4 .

1

3

4

2

6

5

Be careful not to pinch the water tubing and wire harness on the door.

Reattaching the freezer doors

To reattach the freezer doors, replace parts in reverse order

Reattaching the Water Supply Line

1.The Water Line must be fully Inserted to the center of transparent coupler to prevent water leakage from the dispenser.

2.Insert the 2 clips in the install pack and check that each clip holds the line fi rmly.

Center of transparent coupler

clip A (¼”) (6.35mm)

Do not cut the water line. Gently separate it from the coupler.

setting up _07

DA68-02500A.indb 07 2012.5.16 2:52:11 PM