Samsung RSG307AAWP, RSG307AABP Before Using Icemaker, Remove, Install, Before calling service

1.Connect the household water line to the assembled compression fi tting.

- If you are using copper tubing, slip the

compression nut (B) (not included) and ferrule

-When ice does not come out, check for ice stuck in the chute and remove it.

-When Ice Off blinks on the display panel,

(not included) on copper tubing (not included) as

shown.

CAUTION

reinsert the bucket and/or make sure it’s installed properly.

- If you are using plastic tubing (B), insert the

molded end(Bulb) of the plastic tubing (B) into the

compression fi tting.

Do not use without the molded end(Bulb) of CAUTION the plastic tubing (B).

2.Tighten the compression nut (B) onto the compression fi tting. Do not over-tighten the compression nut (B).

3.Turn water on and check for any leakage.

Only connect the water line to a drinkable water source.

If you have to repair or disassemble the water line, cut off 1/4“ of the plastic tubing to make sure you get a snug, leak-free connection.

BEFORE USING ICEMAKER

Remove

- Hold the handle as shown in Figure1.

-Slightly pull up the bottom part.

-Take out the ice bucket slowly.

Install

-Assemble the icemaker in the

reverse order of disassembly.	Figure 1
- Push the bucket in fi rmly until
you hear a clicking sound.
- If the bucket does not fi t into its
place, turn the gear handle on its
back by 90 degrees and reinstall
it again as shown in Figure 2.
Before calling service	Figure 2
- Any sounds you hear when
the ice maker dumps ice into
the bucket are part of normal
operation.
- If you don’t dispense ice for a
long period of time, the ice may
form clumps in the ice bucket.
If ice clumps form, remove the	Ice Chute
remaining ice and empty the
bucket.
10_ setting up

-When the door is open, the Ice and water dispenser do not work.

-If you close the door hard, it may cause water spilling over the ice maker.

-To prevent dropping the ice bucket, use both hands when removing it.

-To prevent injury, be sure to clean up any ice or

water that may have dropped on the fl oor.

-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.

-Be sure not to put your hand or any object into the ice chute. It may cause personal injury or damage mechanical parts.

Removing residual matter inside the water supply line after installing filter.

1.Turn ON the main water supply.

2.Press the Water button and push the Dispenser Lever.

3.Flush 1 gallons of water through the fi lter before use. (Flush approximately 6 minutes.) This will clean the water supply system and remove air from the lines.

4.Additional fl ushing may be required in some households.

5.Open the refrigerator door and make sure there are no water leaks coming from the water fi lter.

A newly installed water fi lter cartridge may cause water to briefl y spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.

DA68-02500A.indb 10 2012.5.16 2:52:18 PM