4.1 <
Network setup (SCX-4725FN only)>
4 Network setup (SCX-4725FN only)
Connecting your machine to a network is available only on the
SCX-4725FN. This chapter gives you step-by-step instructions for setting
up your machine for network connections.
This chapter includes:
•Introduction
Supported operating systems
Configuring TCP/IP
Configuring EtherTalk
Restori ng the ne twork configura tion
Printing a network configuration page
Resetting the network interface
Using SetIP program

Introduction

Once you have connected your machine to a network with an RJ-45
Ethernet cable, you can share the machine with other network users.
You need to set up the network protocols on the machine to use it as your
network printer. Protocols can be set up by the following two methods:

Via network administration programs

You can configure your machine’s print server settings and manage the
machine via the following programs that came with your machine:
SyncThru™ Web Admin Service: Web-based printer management
solution for network administrators. SyncThru™ Web Admin Service
provides you with an efficient way of manageing network devices and
lets you remotely monitor and troubleshoot network machines from
any sith with corporate internet access. Download this program from
http://solution.samsungprinter.com.
SyncThru™ Web Service: A web server embedded to your network
print server, which allows you to:
- Configure the network parameters necessary for the machine to
connect to various network environments.
- Customize printer, copy, and fax settings.
SetIP: Utility program allowing you to select a network interface and
manually configure the IP addresses for use with the TCP/IP protocol.
See Using SetIP program on page 4.2.

Via the control panel

You can set up the following basic network parameters through the
machine’s control panel:
Configure TCP/IP
Configure EtherTalk

Supported operating systems

The following table shows the network environments supported by the
machine:
TCP/IP: Transmission Control Protocol/Internet Protocol
DHCP: Dynamic Host Configuration Protocol
BOOTP: Bootstrap Protocol

Configuring TCP/IP

Your machine can be set up with a variety of TCP/IP network information,
such as an IP address, a subnet mask, and a gateway. There are several
ways in which your machine can be assigned a TCP/IP address,
depending on your network.
Static addressing: A TCP/IP address is assigned manually by the
system administrator.
Dynamic addressing via BOOTP/DHCP (default): A TCP/IP address is
assigned automatically by the server.
Note
Before configuring TCP/IP, you need to set the network protocol
to TCP/IP.
Item Requirements
Network interface 10/100 Base-TX
Network operating
system
Windows 98/Me/2000/XP(32/64bit)/
2003(32/64bit)
Various Linux OS
Macintosh OS 10.3~10.4
Network protocols TCP/IP on Windows
•EtherTalk
Dynamic addressing
server
DHCP, BOOTP