Samsung 4 CHANNEL DVR, SDE-3003, SDE-3001 Record Option, Setting Event Recording Properties

using the DVR

Setting Event Recording Properties

You can set each channel’s resolution, quality and fps for event recordings.

Using the mouse may help make setup easier.

1.	Use the up/down buttons (	) in <Record> window to	REC Quality & Resolution
	move to <REC Quality & Resolution>, and press
				Standard		Event
	[ENTER] button.			CH	Resolution 			Record Rate 		Record Quality 
				Remaining count : 4CIF(L) : 2				2CIF(M) : 4		CIF(S) : 8
2.	Select <Event>.
				2	4CIF(L)			7fps		Level4	
	Event recording setup window appears.			1	4CIF(L)			7fps		Level4	
				4	4CIF(L)			7fps		Level4	
				3	4CIF(L)			7fps		Level4	
3.	Use direction buttons (	) to move to a desired
	item, and select it.

•Resolution : Sets the resolution of the recorded screen.

• Record Rate : Image Per Second, means the frames	OK Cancel
recorded per a second.
• Record Quality : Sets the recording quality.

M The estimated total remaining count means the total number of remaining recordings for both standard and event recordings.

You cannot increase the remaining count if the current remaining count has reached zero or there is no available remaining count from any other page. If this is the case, reduce the remaining count for the current page, or do so for the same channel on any other page.

4.When the Event recording setup is done, press <OK>.

Record Option

You can set the recording to stop or overwrite when the HDD is full.

Using the mouse may help make setup easier.

1.	Use the up/down buttons (	) in <Record> window to
2.	move to <Record Option>, and press [ENTER] button.
	Use direction buttons (	) to move to a desired

Record Option

 Disk End Mode Overwrite

item, and set the value.

•Disk End Mode : If selected <Overwrite>, recording will continue despite the HDD full while overwriting the oldest. If selected <Stop>, the recording will stop when the HDD is full.

•Disk End Beep : If selected <Stop>, the button is activated. If you check it, the beep will sound on the disk full and the recording stops.



Disk End Beep

Auto Delete

The recording information will be deleted.

Do you want to proceed?

OK	Cancel
OK	Cancel

•Auto Delete : If you check it, Record Period setup is activated.

If you specify the auto deletion period, the recording data before the period will be deleted automatically.

 This option will be enabled only if Disk End Mode is set to “Overwrite”.

3.When the recording option setup is done, press <OK>.

50_ using the DVR