Samsung 4 CHANNEL DVR, SDE-3003, SDE-3001 user manual Video Loss Detection, Alarm Schedule

Video Loss Detection

You can set the alarm to be generated on a camera disconnection, which causes a video loss.

Using the mouse may help make setup easier.

1.	Use the up/down buttons (	) in <Event> window to
			Video Loss Detection
	move to <Video Loss Detection>, and press [ENTER]
			CH	Video Loss State 			Alarm 	Alarm Duration 
	button.
			1	OFF			None	10 sec	
	A window of video loss detection area setup appears.		3	Help			None	10 sec	
			2	OFF					
2.	Use direction buttons (	) to move to a desired
			4	OFF			None	10 sec	
					If a video loss event occurs during the event
					the applicable channel will be reset.
	item, and set the value.				recording, the POST recording settings of
							OK
• Video Loss State : Sets whether to activate video loss
	detection.								Help
• Alarm : Sets the alarm output method.						OK	Cancel

For further information on alarm output, refer to “HDD Alarm > Alarm”. (Page 45)

•Alarm Duration : Sets the duration of alarm signal and alarm sound.

•Help : Displays a help message that will appear if a video loss event occurs.

3.When the video loss detection setup is done, press <OK>.

Alarm Schedule

You can set the conditions and operating hours for scheduled alarms.

Using the mouse may help make setup easier.

 USING THE DVR

1. Use the up/down buttons ( ) in <Event> window to move to <Alarm Schedule>, and press [ENTER] button.

2.A window of <Alarm Schedule> settings appears.

3.Alarm : Sets the alarm output method.

For further information on alarm output, refer to “HDD Alarm > Alarm”. (Page 45)

•<ON> : Marked in orange, and always generates alarm on scheduled time.

•<OFF> : Marked in white, no alarm is generated even if an event occurs.

•Event Sync : Marked in Blue, generates alarm only when an event occurs.

•Apply to All Alarm : Applies the configured schedule to all alarms.

M When the alarm is generated on the scheduled time, you can stop the alarm by canceling the schedule.

4.When the Alarm Schedule setup is done, press <OK>.

Alarm Schedule
Alarm1
All	0	1	2	3	4	5	6	7	8	9	10	11 12 13 14 15 16 17 18 19 20 21 22 23
Sun
Mon
Tue
Wed
Thu
Fri
Sat
Hol
OFF			ON				Event Sync					Apply to All Alarm
									OK			Cancel

Alarm Schedule

Alarm1

All	0	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17	18	19	20	21	22	23
Sun
Mon		Apply to All Alarm
Tue
Wed			Apply the alarm scheduling to all?
Thu
Fri									OK				Cancel
Sat
Hol
OFF			ON				Event Sync											Apply to All Alarm

OK Cancel

English _53