Samsung SDR5100 Video Loss Detection, Alarm Schedule, Window of alarm Schedule settings appears

main menu

Video Loss Detection

You can set the alarm to be generated on a camera disconnection, which causes a video loss.

Using the mouse may help make setup easier.

1.Use the up/down buttons ($%) in <event> window to move to <Video Loss Detection>, and press [enTeR] button.

A window of video loss detection area setup appears.

2.Use direction buttons ($%_ +) to move to a desired item, and set the value.

•Video Loss State : Sets whether to activate video loss detection.

•Alarm : Sets the alarm output method.

`For further information on alarm output, refer to “HDD Alarm > Alarm”. (Page 49)

Video Loss Detection
CH	Video Loss State 		Alarm 	Alarm Duration 
1	OFF		None	10 sec	
2	OFF		None	10 sec	
3	Help				
4	OFF		None	10 sec	
5	OFF	If a video loss event occurs during the event		10 sec	
			None
6	OFF	recording, the POST recording settings of the		10 sec	
			None
7	OFF	applicable channel will be reset.		10 sec
			None		
8	OFF		OKNone	10 sec	
			Previous/Next Page
					Help
		OK	Cancel

•Alarm Duration : Sets the duration of alarm signal and alarm sound.

•Help : Displays a help message that will appear if a video loss event occurs.

3.When the video loss detection setup is done, press <OK>.

alarm Schedule

You can set the conditions and operating hours for scheduled alarms.

Using the mouse may help make setup easier.

1. Use the up/down buttons ($%) in <event> window to
	Alarm Schedule
move to <alarm Schedule>, and press [enTeR] button.

2. A window of <alarm Schedule> settings appears.	BEEP
	All	00	01	02	03	04	05	06	07	08	09	10	11	12	13	14	15	16	17	18	19	20	21	22	23
	Sun
• Alarm : Sets the alarm output method.
	Mon
	Tue
` For further information on alarm output, refer to “HDD Alarm >	Wed
	Thu
	Fri
Alarm”. (Page 49)	Sat
	Hol
• <On> : Marked in orange, and always generates alarm on
	OFF			ON			Event Sync												Apply to All Alarm
scheduled time.
• <OFF> : Marked in white, no alarm is generated even if an										OK			Cancel
event occurs.

•Event Sync : Marked in Blue, generates alarm only when an event occurs.

M ` When the alarm is generated on the scheduled time, you can stop the alarm by canceling the schedule. 3. When the Alarm Schedule setup is done, press <OK>.

56_ main menu