English-5-7
1. DWELLTIME SETUP
- Pressing SEQUENCE button in Single Screen will bring up the SEQUENCE MODE. You may set
the time display for each channel. If you set zero (0) seconds as the DWELLTIME for a particular
channel, the set channel will be skipped and next channel will be shown. You may
set time in the QUAD-A, QUAD-B screens.
[0SEC, 1SEC, 2SEC, 3SEC.................... ~ 60SEC]
- Use
,
,
¥
,
, key to make changes.
5-5) ALARM SETUP•
Function:Allows users to set the ALARM MODE for each camera.
•
Setting method:Move to #6. ALARM MENU by using
KEYin the SETUP MENU, and
press the ENTER SWITCH to display the OSD as shown in the figure below. (The figure shows
the initial setting status.)
(1) CAM1 to CAM8 item sets whether the alarm sensor connected to the camera is used or not.
(ON: Alarm function setting, OFF: Alarm function canceling)
(2) HOLD TIME item sets time to freeze alarm operation when alarm occurs.
(HOLD TIME to be set: 05SEC ~ 1MIN ~ 30MIN)
* Note : If you want to carry alarm operation, you must pre-set ALARM ON/OFF TIME item in
monitor before CAMERAALARM is set to ON. If you do not pre-set ALARM ON/OFF
TIME item in advance, alarm operation is not carried though CAMERAALARM is set to ON.
(3) ALARM TONE sets whether or not alarm tone (high-pitched tone)sounds when an ALARM or
VIDEO LOSS occurs.
(ON: ALARM TONE operation, OFF: Cancel)
05/01/05 00:00:01
CAM1 ON
CAM2 ON
CAM3 ON
CAM4 ON
CAM5 ON
CAM6 ON
CAM7 ON
CAM8 ON
HOLD TIME 05SEC
ALARM ON TIME 00:00
ALARM OFF TIME 00:00
ALARM TONE ON
ALARM SETTING