4. POSTALARM TIME LIMIT
- Recording is performed up to the time set in MAIN ALARM TIME. Then data is further recorded
up to the time set in POSTALARM TIME LIMIT.
[OFF ,10SEC ,20SEC ,30SEC ,1MIN ,2MIN ,3MIN ,4MIN ,5MIN]
- Use
,
,
¥
,
, key to make changes.
5. MOTION DETECTION
- When MOTION DETECTION is set to ON, recording will start whenever a motion in the input
video is detected.
[ON/OFF]
- Use
,
,
¥
,
, key to make changes.
6. SENSITIVITY
- MOTION DETECTION SENSITIVITYcan be set when user set the MOTION DETECTION.
There are three stages -- HIGH/NORMAL/LOW.
[HIGH/NORMAL/LOW]
- Use
,
,
¥
,
, key to make changes.
7. MOTION CH SETUP
- Set the channel that you want to detect MOTION.
- MOTION can be detected only on channels that are set to ON.
The following screen shows that MOTION recording is in progress when MOTION happens. It
shows MOTION happens on channels 1 and 2. An “M” mark is displayed next to each channel
title to show that MOTION happens.
[ON/OFF]
05/01/05 00 : 00 : 01
CAM7 CAM8
MCAM4 CAM5 CAM6
CAM1 CAM2 CAM3
English-5-9
05/01/05 00:00:01
CAMERA1 OFF
CAMERA2 OFF
CAMERA3 OFF
CAMERA4 OFF
CAMERA5 OFF
CAMERA6 OFF
CAMERA7 OFF
CAMERA8 OFF
MOTION AREA : ON[FULL] OFF[EMPTY]
MOTION CH SETUP