Samsung SNB-3000(P) user manual To reset the system, To set the Https

4.When the software update is completed, you will be prompted to restart the system.

5.Click [OK] to restart the system.

Since the current connection is disconnected, you have to connect to the system again.

J	 If the network is disconnected, the power supply fails, or the PC abnormally operates during the
	update, the system does not work at all.

To reset the system

Restart or reset the system if it does not work properly or causes a problem. Select <system> - <reset>.

The Reset window appears.

Restart : Restarts the system.

Factory default : Resets the system

settings to the factory defaults with following two options:

-Except network parameter : Resets all settings except for the Network Parameters.

-All : Restores all settings to the default.

This works the same as pressing the [RESET] button on the rear of the camera.

J	 After the system is reset or restarts, you should try to connect to the camera again.
	 It takes several minutes until the system completes rebooting. Wait until the system rebooting is
	completed and try to connect again.
	 After executing <Factory default>, you must run the <IP Installer.exe> program to change the
	basic network settings such as IP address, Subnet mask, Gateway, etc., before you can connect to
	the Internet.

To set the HTTPS

1.Select <System> - <HTTPS>. The HTTPS setup window appears.

Secure connection system : Select a secure connection system to use. To use the secure connection mode requiring the public certificate for the secure connection system, you must have installed a signed certificate issued by a certificate authority on your system.

Install a public certificate : To install the certificate to camera, you need to type a certificate name (it can be arbitrarily assigned by user), certificate file issued from the authority and a key file. When done, click [Install].

If the certificate is installed successfully, the user-defined certificate name will be displayed. Also, the option button of <HTTPS (Secure connection mode using the public certificate)> in the upper side becomes activated.

n ee cr p S●tuSe

English _57