Samsung SNS-110P manual When normally-functioning SNS-110 is suddenly not connecting

When the post-version software still operates, even after you have installed the updated version.

(1)When you upgrade to the latest version of the software, the "Uploading is successful! New code will be loaded after reset" message appears. When this message appears, reset or restart SNS-110 and the new software will reboot the system.

(2)To check the version, press "about" in "Administrator Mode" in SNS-110.

When normally-functioning SNS-110 is suddenly not connecting

(1)Check if the LED light is blinking on the front of SNS-110.

(2)If it isn't, contact the network manager to check the status of network. If no fault is identified from the network, refer to Supplement B, Factory Default, and set the information back to its original status, and Use chapter 4 to set an IP address.

(3)If the system does not work even after a new IP Address has been selected, contact your local service center.

When SNS-110 does not work after downloading to upgrade to the latest version of the S/W of SNS-110

(1)If you upgraded SNS-110 by using a separate file other than one was supplied by Samsung Electronics, it becomes non-functional.

(2)If your SNS-110 doesn't function at all, even though the software normally supplied by Samsung Electronics was used for upgrading., then contact your vendor or Service Center.

87