Samsung SNS-110P manual Password

③Pswd Enable

Restricts the access from other users. If you check the check box of "Pswd Enable" and click "Apply" button, you should input registered username and its password in Log-in window to access to the Application mode.

If you don’t check the check box of "Pswd Enable", anyone is accessible to the Application mode.

Caution	Anyone, who is accessible to Administration mode, may change configuration
	of SNS-110. If the configuration is deleted or altered, the system may be
	damaged or malfunction. Therefore, factory default is set up with root
	password.
	After the initial installation, you are strongly recommended to change the root
	password and restrict the access from other users.

(4)S/W Upgrade

Upgrade the currently installed program in SNS-110 to the most updated version.

①Download the updated program version from Samsung Electronics web site . (www.samsungelectronics.com), or from SNS-110 service man. The file name of SNS-110 program is sns110_vXXX_XXXX.bin.

②Save the updated program version in the directory of SNS-110-connected PC.

③Click "Browse" and select the updated program, sns110_vXXX_XXXX.bin, in the directory. The selected file will be saved in the browse window.

④Click "Install" and open dialog window. You will see caution message, then click "OK" to start program upgrade. Upon the upgrade completion, you will see another dialog window. You must wait approximately for 2 minutes.

Caution	Wait until the "Upgrading is successful! New code will be loaded after
	reset" message appears. Rebooting SNS-110 before this message can
	cause fatal damage to the machine.

⑤Reboot SNS-110 after the upgrade being completed as shown below.

●Press "Reset" button on the front panel.

●Turn off and then on SNS-110.

⑥After successfully upgrade the program, execute web browser and Log-in.

48