Issues | Solutions and Explanations |
There is a plastic smell from the TV. | • This smell is normal and will dissipate over time. |
|
|
The TV Signal Information is unavailable | • This function is only available with digital channels from an Antenna / RF/Coax connection (p. 21). |
in the Self Diagnostic Test menu. |
|
|
|
The TV is tilted to the side. | • Remove the base stand from the TV and reassemble it. |
|
|
There are difficulties assembling the stand | • Make sure the TV is placed on a flat surface. It is necessary to use magnetized screw driver if you |
base. | cannot remove the screws from the TV. |
|
|
The channel menu is greyed out. | • The Channel menu is only available when the TV source is selected. |
(unavailable) |
|
|
|
Your settings are lost after 30 minutes or | • If the TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes. Change |
every time the TV is turned off. | the settings from Store Demo mode to Home Use mode in the Plug & Play (Initial setup) procedure. |
| Press the SOURCE button to select TV mode, and go to MENU → Setup → Plug & Play (Initial |
| setup) → ENTERE. (p. 7) |
You have intermittent loss of audio or | • Check the cable connections and reconnect them. |
video. | • Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables are |
| flexible enough for long term use. If mounting the TV to the wall, we recommend using cables with 90 |
| degree connectors. |
|
|
You see small particles when you look | • This is part of the product’s design and is not a defect. |
closely at the edge of the frame of the TV. |
|
|
|
The PIP menu is not available. | • PIP functionality is only available when you are using a HDMI, PC or components source (p. 20). |
|
|
You turned the TV off 45 minutes ago, and | • It is normal. The TV operates the OTA (Over The Aerial) function itself to upgrade firmware |
it turned on again. | downloaded whilst your watching TV. |
|
|
There are recurrent picture/sound issues. | • Check and change the signal/source. |
|
|
A reaction may occur between the rubber | • To prevent this, use felt pads on any surface of the TV that comes in direct contact with furniture. |
cushion pads on the base stand and the |
|
top finish of some furniture. |
|
|
|
✎✎This TFT LED panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.
|
| Specifications |
|
|
|
|
|
| |
Panel native |
| 1920 x 1080 @ 60 Hz |
| |
|
|
|
|
|
Environmental Considerations |
|
|
|
|
Operating Temperature |
| 10°C to 40°C (50°F to 104°F) |
| |
Operating Humidity |
| 10% to 80%, |
| |
Storage Temperature |
|
| ||
Storage Humidity |
| 5% to 95%, |
| |
|
|
|
| |
Stand Swivel (Left / Right) |
|
| ||
|
|
|
|
|
Model Name | UA32C6900 | UA40C6900 | UA46C6900 | UA55C6900 |
Screen Size | 32 inches | 40 inches | 46 inches | 55 inches |
Sound |
|
|
|
|
(Output) |
| 10W x 2 |
| 15W x 2 |
|
|
|
|
|
Dimensions (WxDxH) |
|
|
|
|
Body | 768.8 X 28 X 482.4 mm | 956 X 28 X 588.4 mm | 1090.8 X 28 X 662.8 mm | 1282 X 28 X 772 mm |
With stand | 768.8 X 237.4 X 538.3 mm | 956 X 267.7 X 647.1 mm | 1090.8 X 303 X 723.8 mm | 1282 X 303 X 832.7 mm |
Weight |
|
|
|
|
Without Stand | 8.5 kg | 12.4 kg | 16 kg | 20.3 kg |
With Stand | 10 kg | 14.5 kg | 18.3 kg | 22.6 kg |
✎✎Design and specifications are subject to change without prior notice.
✎✎For information about power supply, and more about power consumption, refer to the label attached to the product.