Samsung VCR8875T3A/XEO, VCR8875T3A/XEF manual Operating the cleaner, Installation order

Operating the cleaner

Installing the robotic vacuum cleaner

Installation order

1.Turning the Power Switch on or off

To use the robotic vacuum cleaner, you must turn on the Power Switch at the bottom of the main unit.

2.Installing the Charger

To charge the robotic vacuum cleaner, you must first install the charger.

Since the battery is discharged when the product is purchased, you must fully charge the battery before use.

3.Charging the Battery

You should charge the battery completely before using the robotic vacuum cleaner.

4.Installing the VIRTUAL GUARD

You can confine the robotic vacuum cleaner to a particular section by using Fence (virtual wall) mode or clean several sections one by one using Guard (virtual door) mode.

Turning the Power Switch on or off

To use the robotic vacuum cleaner, you must turn the

Power Switch on.

If you turn the Power Switch off, all settings will be reset.

1. Turn over the main unit and turn the Power Switch on.

-If the icons are not turned on, it indicates that the battery charge is depleted. In this case, dock the robotic

vacuum cleaner to the charger station after turning the Power Switch on.

- Note that turning the Power Switch off will reset all settings.

-If no key is pressed for approximately 5 minutes

after turning the power on, the power is automatically cut to prevent the battery discharging.To turn the power on again, press and hold the power (Run/Stop) button on the main body or on the remote control for a short while.

If the Power Switch is turned off, the robotic vacuum cleaner will not be charged CAUTION even if it is docked with the charger station.

20_ Operating the cleaner