Connecting yepp to PC with USB cable

3 Plug one end of the USB cable into the USB port on the back of the PC.

4 Connect the opposite end of the USB cable to the USB cable port on the bottom of the yepp.

●If you disconnect the USB cable from your PC while

implementing a command or initializing during USB driver installation, your PC may not function correctly.

● The yepp will automatically turn on.

5	USB driver is installed with a message saying that it	USB
	USB driver is installed with a message saying that it
	is searching for a new device. You may not see the
	is searching for a new device. You may not see the	connect
	display screen during installation.	connect
	display screen during installation.
	Go to the device manager to check that installation	cable
	has been successfully completed.	cable
	has been successfully completed.
6	Upon installation of the USB driver
6	"SAMSUNG YP-55”will appear in the
	[System Properties] ➝ [Device Manager].

	REC / ENC
MODE	VOL

Note :

Windows 98:

Control Panel ➝ System ➝ Device Manager ➝

Universal Serial Bus controllers/Samsung YP-55 Class

Windows 2000:

Control Panel ➝ System ➝ Hardware ➝

Device Manager ➝ Universal Serial Bus controllers ➝

USB Mass Storage Device Windows XP:

Control Panel ➝ System ➝ Hardware ➝

Device Manager ➝ Universal Serial Bus controllers ➝

7 When USB driver is not Installed automatically, refer to next page.

Note :

For WinXP, the following window will appear whenever you connect the USB cable to your yepp.