Presetting stations in AM/FM modes

There are 5 preset stations each for AM and FM radio. They are used in the same way for each waveband.

1. Press the Standby button to switch on your radio.

2. Press the Band button to select the desired waveband. Tune to the required radio station as previously described.

3.Press and hold the required main Preset button (1 to 5) until the display shows “P1” after the frequency. The station will be stored

using the preset number. Repeat this procedure for the remaining presets as you wish.

4.Preset stations which have already been stored may be overwritten by following the above procedure if required.

Recalling a preset in AM/FM modes

1. Press the Standby button to switch on your radio.

3

 

2.Select the required waveband by pressing the Band button.

3.Momentarily press the required main Preset button to cause your radio to tune to one of the stations stored in the 5 main presets.

15

Page 16
Image 16
Sangean Electronics K-200 manual Presetting stations in AM/FM modes, Recalling a preset in AM/FM modes