Sansui HDLCD1900A manual Using an AV Amplifier with built-in digital surround

Connections to other equipment

Using an AV Amplifier with built-in digital surround

If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround audio that sounds just like the movie.

Connect an AV amplifier with built-in Dolby Digital decoder, or etc. as shown below.

Rear of the LCD TV

Front

Subwoofer Speaker (Right)

TV

Front

Speaker

(Left)

Coaxial DigitalAudio Output _ _ ,i!

Coaxial digital cable

(not supplied)

ToCoaxial Digital Audio Input

O

_ S;_°l_nd(Left)_ iPihi nd

AV Amplifierwith built-in digJta surround decoder as listed above

NOTE:

•Coaxial digital audio output is active only when receiving digital broadcasting, not when receiving analog broadcasting.

•Coaxial digital audio output doesn't output the sound of external inputs.

To connect the LCD TV to a PC (Personal Computer)

Before you connect this LCD TV to your PC, change the adjustment of your PC'sResolution and Refresh rate

(60 Hz).

Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA connector PC MONITOR on the rear of the LCD TV. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the AUDIO connector of the PC AUDIO IN jack of the LCD TV.

Press INPUT SELECT on the remote control to select PC mode.

Switch on the computer. The LCD TV can operate as the computer monitor.

Rear of the LOD TV

			Monitor	Display	modes
			MODE	Resolution	Refresh rate
			VGA	640x480	60Hz
	i	1	VGA	720x400	70Hz
PC AUDIO IN jack			SVGA	800x600	60Hz
clTe			XGA	1024x768	60Hz
Audio cord (not supplied)			WXGA	1280x768	60Hz
			WXGA	1280x720	60Hz
			WXGA	1360x768	60Hz

VGA cable (not supplied)

NOTE:

To return to normal mode

Press INPUT SELECT again.

• The on-screen displays will have a different appearance in PC mode than in TV mode.

14 • If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.