Remove Mounting Brackets | Sanus Systems LA112 instruction

2: Remove Mounting Brackets

[27]

You must remove the two TV Mounting Brackets from the LA112 before attaching the arm to the wall plate.

Remove the hex screws [A] from the mounting brackets [03]. Pull the safety clips [04] from the back of the mounting brackets, then remove the mounting brackets from the arm assembly.

[A]

[27]

[04]

[03]

6901-100189 <01>

Image 6

Sanus Systems LA112 manual Remove Mounting Brackets

Contents

LA112 Backed by CLO Supplied Parts and Hardware Measure width between holesMeasure height between holes 10 x 11 x 12 x 08 x 01 x 02 x 04 x05 x 06 x 07 x 14 x 6901-100189 Remove Wall Plate from Arm Remove Mounting Brackets Mount Wall Plate For Wood Stud WallsMin .5 cm 2.5 For Concrete Block or Brick Walls Install Arm Assembly to Wall Plate Set the Monitor Width Selector Set Install Mounting Brackets Top18, 19 12, 13, 14, 15, 16 21, 22 For Power Outlets Located Outside the Bellows Route Cables For Power Outlets Located Inside the Bellows Install Monitor to Wall Plate Calibrate the Arm Reset the LA112 Home PositionAdjust Monitor Position Calibrate Arm to the Monitor Using the Remote Control CBL mode Page Up Programming the Preset Position Keys Press Programming the Remote to Operate an Existing TV Programming Codes TV Programming CodesTV Brand Code Numbers TMK NECSSS RCA JVC DVD Programming CodesDVD Brand Code Numbers KLH VCR Programming Codes VCR Brand Code Numbers Teac STS For Cable Boxes Brand Code Numbers Arm Will Not Move TroubleshootingHow to Correct A1,A2, or A3 is displayed on control box Power Switch Control Box LED Display Selector Set Button C1,C2,C3 or C4 is displayed on control box HC is displayed on control box H1,H2, or H3 is displayed on control box Maintenance If Your TV Leans Forward at the Home Position Home Automation Controls Product Information WarrantyPurchaser Information To register by mail