For Power Outlets Located Inside the Bellows
CauTION
Avoid potential property damage! Keep all cables away from the center beam of the arm assembly. Do not place cables closer than 5cm (2 in.) on either side of the beam.
|
| [B] |
| [A] | TV Power & |
Cable Tie Anchor | AV Cable Loop | IR Receiver Hook |
| ||
[C] |
|
|
Cable Bar |
|
|
Cable Hole |
|
|
Bellows
No Cable | No Cable |
2” (5 cm) | 2” (5 cm) |
TV Power outlet 
inside belows.
[06]
Bottom Cross Bar
AV Cables |
| TV Power |
| |
to TV |
|
| ||
AV Cables from | Cord | IR Receiver Eye | ||
| ||||
| [08] | |||
| Component |
|
Route the AV cables over the bottom cross bar, through the left cable loop [A], then through the cable access port at the bottom of the arm assembly.
Route the power cord [08] over the bottom cross bar, through the opposite cable loop [B], then through the cable access port at the bottom of the arm assembly. Disconnect the plug end of the IR receiver cable [06] and route the cable over the bottom cross bar, through the right cable loop [B], then through the access port at the back of the arm assembly.
Secure the cables to the bottom cross bar with cable ties [26] as shown. Be sure to keep all cables at least 5cm (2 in.) away from the center beam!
Check that the cables are long enough to allow free movement of the arm assembly, but are not long enough to get caught in the mechanical parts of the arm assembly. Using the remote, adjust the arm up, down, and side to side through its full extension. Secure the cables to the cable bar [C] at the back of the arm assembly.
