Sanyo PLC-WU3800 owner manual Part Names and Functions, ⑤ LAN Connection Terminal

Part Names and Functions

Rear Terminal

① ② ③ ④ ⑤

* ⑩ ⑨ ⑧ ⑦ ⑥

①CONTROL PORT

When controlling the projector with RS-232C, connect the control equipment to this connector with the serial control cable.

②COMPUTER IN 1 / COMPONENT IN

Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.15,17).

③COMPUTER IN 2 / MONITOR OUT

–Connect computer output to this terminal (p.15).

–This terminal can be used to output the incoming analog RGB signal and component signals from COMPUTER IN 1/COMPONENT IN terminal to the other monitor (p.15).

④HDMI

Connect the HDMI signal (including sound signal) from video equipment or the DVI signal from computer to this terminal (pp.15, 17).

* is registered trademarks of HDMI

Licensing, LLC.

⑤LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual of “Network Set-up and Operation”).

⑥S-VIDEO IN

⑦AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.15 -17).

This terminal outputs sound from AUDIO IN terminal (⑧ or ⑨).

Never plug headphones and earphones into AUDIO OUT jack.

⑧COMPUTER 1 COMPONENT / COMPUTER 2 AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to ②, ③ or ④ to this jack. (pp.15, 17)

⑨AUDIO IN

Connect the audio output signal from video equipment connected to ⑥ or ⑩ to this jack.

For a mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.16).

⑩VIDEO IN

Connect the composite video output signal to this jack (p.16).

Connect the S-VIDEO output signal from video equipment to this jack (p.16).

10