Manuals / Brands / Computer Equipment / Projector / Sanyo / Computer Equipment / Projector

Sanyo PLC-XE33 Network configuration, Connecting to the LAN line

1 58

Download 58 pages, 3.7 Mb

12

Chapter 2 Setup Procedures

Setting Procedure

Setting procedures and contents differ depending on the LAN installation location.

When installing, consult your system administrator to set up the LAN appropriately.

Connect the LAN cable to the LAN connection terminal of the projector.

Network configuration

Set the Wired LAN network through the projector menu. Detailed network settings will be

made with browser. Refer to “3. Basic setting and operation” (p.17-30). First, complete the

settings described in this chapter before performing steps in “3. Basic setting and opera-

tion.”

1. Select “LAN mode select” in the Network menu, and press Point 8 or SELECT button.

2. Select similar LAN environment among LAN1, LAN2 and LAN3 with the Point ed but-

tons. Then the Menu will disappear, the “Please wait...” message will appear, and switch-

ing operation will start. Switching will take a while and the projector’s LINK/ACT Lamp

will be on or blink, and after completing the operation, the “Please wait...” message will

disappear.

Connecting to the LAN line

LAN Cable

LAN Connection

Terminal

LINK Lamp (Green)

Light green when the

projector is connected to

the network correctly.

ACT Lamp (Orange)

Blink orange when the

projector is sending or

receiving the data.

Contents

Main Compliance Federal Communications Commission Notice Safety instructions Table of contents Page Features E-Mail Alert function (+p.25) Web Management function (+p.31) SNMP Agent function (+p.29) SNMP Manager function Required operating environment for computers When operating the projector via networks, computers should meet the operating envi- ronment below. Network specifications of the projector LAN Terminal The limitation*1 of connection between the projector and hub or computer Notice Expression/Abbreviation Use of this manual Trademarks Flow of installation Page Page Setting Procedure Network configuration Connecting to the LAN line Page Network PIN code Network information Network factory default Wired LAN factory default settings Page Login the setting page of the projector [3] Display of main setting page Main setting page in the display How to use the setting page Page Initial setting Network PIN code setting PJLink and password setting What's PJLink? PJLink Notice Network configuration E-mail setting 1 2 3 E-mail setting When internal PJ power circuit is failed: Examples: Type and contents of alert mail When internal PJ temperature is too high: When PJ lamp replacement time is reached: When lamp corres. value reaches preselect use time: SNMP setting Page Page Power control and status check About projector condition Control Input System Page Image adjustment Input source PC adjustment Setting up the projector Screen setting Setting 1 Setting 2 Setting 3 Information Indication of the lamp status Page Chapter 5 Appendix Examples of connection Peer-To-Peer connection To another network Connecting the projector (PJ01) to the control computer (PC05) directly. * UTP cross cable The gateway (Router) installed in the network Connecting the projector (PJ01) to the control computer (PC05) via the gateway. Oce Gateway (Router) To another network Use of telnet Control Page Web browser setting Active Script/JavaScript enable Proxy setting Examples: OS/Browsers Page Netscape Navigator v.7.1 JavaScript Setting MAC OS X v 10.4 Safari v.3.2.1 JavaScript enable setting 1 2 3 Q&A Installation/Access Q A Q from a remote location?