Sanyo PLC-XE33 SNMP setting

29

ENGLISH

✐The SNMP agent provided with this projector is based upon MIB-2 defined by RFC1213. For private

MIB information, refer to file "Mibinfo/XUPjNet.mib" in the CD-ROM.

SNMP setting

This projector provides a SNMP (Simple Network Management Protocol)

agent function. The SNMP consists of a manager and agents. The group

which communicates information each other with SNMP is called

"Community". There are two access modes in a community, Refer (read only) and Set (read-

write). This projector allows to use Refer (read only) only. The SNMP message informs the pro-

jector status called "Trap" to an administrator. Click

SNMP Setting

on the main menu and

set up each item.

Item ........................................Description

Contact ............................................... Enter user name of the projector etc. (optional)

Place .....................................................Enter place of the projector (optional)

Community name(refer) ....... Enter community name (read only). Default name is "public".

PJ information

SNMP setting

Item ........................................Description

Community name ...................... Enter community name to send "Trap". Default name is "public".

Add address .................................... Enter IP address of the SNMP manager computer to receive "Trap".

Trap

Contents

Main Compliance Federal Communications Commission Notice Safety instructions Table of contents Page Features E-Mail Alert function (+p.25) Web Management function (+p.31) SNMP Agent function (+p.29) SNMP Manager function Required operating environment for computers When operating the projector via networks, computers should meet the operating envi- ronment below. Network specifications of the projector LAN Terminal The limitation*1 of connection between the projector and hub or computer Notice Expression/Abbreviation Use of this manual Trademarks Flow of installation Page Page Setting Procedure Network configuration Connecting to the LAN line Page Network PIN code Network information Network factory default Wired LAN factory default settings Page Login the setting page of the projector [3] Display of main setting page Main setting page in the display How to use the setting page Page Initial setting Network PIN code setting PJLink and password setting What's PJLink? PJLink Notice Network configuration E-mail setting 1 2 3 E-mail setting When internal PJ power circuit is failed: Examples: Type and contents of alert mail When internal PJ temperature is too high: When PJ lamp replacement time is reached: When lamp corres. value reaches preselect use time: SNMP setting Page Page Power control and status check About projector condition Control Input System Page Image adjustment Input source PC adjustment Setting up the projector Screen setting Setting 1 Setting 2 Setting 3 Information Indication of the lamp status Page Chapter 5 Appendix Examples of connection Peer-To-Peer connection To another network Connecting the projector (PJ01) to the control computer (PC05) directly. * UTP cross cable The gateway (Router) installed in the network Connecting the projector (PJ01) to the control computer (PC05) via the gateway. Oce Gateway (Router) To another network Use of telnet Control Page Web browser setting Active Script/JavaScript enable Proxy setting Examples: OS/Browsers Page Netscape Navigator v.7.1 JavaScript Setting MAC OS X v 10.4 Safari v.3.2.1 JavaScript enable setting 1 2 3 Q&A Installation/Access Q A Q from a remote location?