Sanyo PLC-XE34 Lamp Handling Precautions, Order Replacement Lamp, Model No.. of your projector

Models: PLC-XE34

1 78
Download 78 pages 40.99 Kb
Page 63
Image 63
ORDER REPLACEMENT LAMP

Maintenance and Cleaning

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

Model No.. of your projector

: PLC-XE34

Replacement Lamp Type No.

: POA-LMP142

 

 

(Service Parts No. 610 349 7518)

LAMP HANDLING PRECAUTIONS

This projector uses a high-pressure lamp which must be handled carefully and properly.

Improper handling may result in accidents, injury, or create a fire hazard.

Lamp life� may�� differ�� f�rom lamp to lamp and according to the environment� of� use. There is no guarantee of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time than other similar lamps.

If�� the proj�ector indicates that the lamp should be replaced,�� i.e.,�� if� the LAM��P REP� LAC� E indicator lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.

(Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.

A� Lamp may�� expl� ode as a result of� v�ibration,�� shock or degradation as a result of� hours of� use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN..

If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized service center for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.

63

Page 63
Image 63
Sanyo PLC-XE34 Lamp Handling Precautions, Order Replacement Lamp, Model No.. of your projector, Replacement Lamp Type No