Setting
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the input signal is interrupted and no button is pressed for a certain period.
When the input signal is interrupted and no button is pressed for 30 seconds or more, the timer display with "No signal" message will appear. The countdown will start to turn off the lamp.
Select one of the operations.
Ready ...............When the lamp has been fully cooled
down, the POWER indicator changes to green blinking. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the top control or remote control unit is pressed.
Shut down ......When the lamp has been fully cooled
down, the power will be turned off. Off . . . . . . . . . . .Power management function is off.
Then set the countdown timer with the Point 78 buttons.
✔Note:
Factory default is “Ready: 5 min.”
On start
When this function is “On”, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.
✔Note:
Be sure to turn the projector off properly (see “Turning Off the Projector” on page 20). If the projector is turned off in the incorrect sequence, the On start function does not operate properly.
Lamp control
This function allows you to change brightness of the screen.
Auto | The brightness according to the input |
| signal (between High and Eco mode). |
High | Brighter than the Normal mode. |
Normal | Normal brightness |
Eco | Lower brightness reduces the lamp power |
| consumption and extends the lamp life. |
Power management
Time left before Lamp is off.
Press the SELECT button at Power management and this box will appear. Choose one of three settings with the Point 7 8 buttons, and
go to the timer with the Point ed buttons and set time with the Point 7 8 buttons.
46
