Sanyo PLC-XU 101 owner manual Basic Operation, Turning On the Projector, PIN Code Input Dialog Box

Basic Operation

Turning On the Projector

1	Complete peripheral connections (with a computer,
	VCR, etc.) before turning on the projector.
2	Connect the projector’s AC power cord into an AC
	outlet. The POWER indicator lights red.
	Open the slide shutter by sliding the slide shutter
	lever. (see page 53)
3	Press the ON/STAND-BY button on the top control or
	the remote control. The POWER indicator lights green
	and the cooling fans start to operate. The preparation
	display appears on the screen and the count down
	starts.
4	After the countdown, the input source that was
	selected the last time and the lamp control status icon

(see page 46) appear on the screen.

If the projector is locked with a PIN code, PIN code input dialog box will appear. Enter the PIN code as instructed below.

Enter a PIN code

Use the Point ed buttons to enter a number. Press the Point

8button to fix the number and move the red frame pointer to the next box. The number changes to “✳.” If you fixed an incorrect number, use the Point 7 button to move the pointer to the number you want to correct, and then enter the correct number.

Repeat this step to complete entering a four-digit number.

After entering the four-digit number, move the pointer to “Set.” Press the SELECT button so that you can start to operate the projector.

If you entered an incorrect PIN code, “PIN code” and the number (✳✳✳✳) will turn red for a moment. Enter the correct PIN code all over again.

What is PIN code?

PIN (Personal Identification Number) code is a security code that allows the person who knows it to operate the projector. Setting a PIN code prevents unauthorized use of the projector.

A PIN code consists of a four-digit number. Refer to the PIN code lock function in the Setting Menu on page 48 for locking operation of the projector with your PIN code.

CAUTION ON HANDLING PIN CODE

If you forget your PIN code, the projector can no longer be started. Take a special care in setting a new PIN code; write down the number in a column on page 65 of this manual and keep it at hand. Should the PIN code be missing or forgotten, consult your dealer or service center.

16

The preparation display will disappear after 30 seconds.

Selected Input Source and Lamp Control

Lamp control status

(See page 46 for Lamp control status.)

✔Note:

•The Filter warning and Lamp replacement icons may appear on the screen depending on the usage state of the projector.

PIN Code Input Dialog Box

After the OK icon disappears, you can operate the projector.

✔Notes:

•When the Logo select function is set to “Off,” the logo will not be shown on the screen (p.43).

•When the “Countdown off” or “Off” is selected in the Display function, the countdown will not be shown on the screen (p.42).

•During the countdown period, all operations are invalid.

•If the correct PIN code number is not entered within three minutes after the PIN code dialog box appeared, the projector will be turned off automatically.

•The “1234” is set as the initial PIN code at the factory.

•When the Input Search function is set to “On2”, the input signal will be searched automatically (p.45)

19