CONNECTING PROJECTOR
TERMINALS OF PROJECTOR
This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity of signals from computers and video equipment.
3 TERMINAL SLOTS (Factory set)
INPUT/OUTPUT TERMINALS
SERIAL PORT IN | IN | LINK A | OUT |
|
| |
SERIAL PORT OUT | R/Pr | G/Y | B/Pb | H/HV | V | |
|
| |||||
R/C JACK | USB |
|
| DVI |
|
|
|
|
|
|
|
| |
AUDIO OUT |
|
|
|
|
| |
R | L |
|
|
|
|
|
| RESET |
|
|
|
|
|
(MONO)
IN LINK B OUT
AUDIO | CONTROL PORT |
R | L |
(MONO) | |
AUDIO | CONTROL PORT |
R | L |
(MONO)
INPUT 4 INPUT 3 INPUT 2 INPUT 1
5 BNC Terminal
DVI Terminal
REPLACEMENT OF TERMINAL
NOTE; When replacement of terminal board, MAIN ON/OFF switch should be OFF position.
1 | Remove 2 Screws on terminal. |
2 | Pull out terminal by holding handle. |
3 | Replace terminal. Insert terminal along Guide to fit Plug |
into Socket. | |
4 | Tighten screws to secure terminal. |
NOTES ON ORDERING OR USING OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board (Terminal Board), contact your sales dealer. When con- tacting the sales dealer, tell the Optional Control Number (Op.cont.No.) in the menu that is located under Language Select Menu. (See page 38.)
Screws
Guide
Socket
Plug | Figure shows DVI terminal. |
12
