Appendix
Lamp Replacement
When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly.
This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one.
TOP CONTROL
WARNING
TEMP.RE
LAMP
REPLACEON-OFF
|
| CAUTION |
| |
ALLOW A PROJECTOR TO COOL, FOR AT LEAST 45 | FOR CONTINUED SAFETY, REPLACE WITH A LAMP | |||
ASSEMBLY OF THE SAME TYPE. |
| |||
MINUTES BEFORE YOU OPEN LAMP COVER. THE |
| |||
DO NOT DROP A LAMP ASSEMBLY OR TOUCH A | ||||
INSIDE OF A PROJECTOR CAN BECOME VERY | ||||
GLASS BULB! THE GLASS CAN SHATTER AND MAY | ||||
HOT. | ||||
CAUSE INJURY. |
| |||
|
| |||
Follow these steps to replace the lamp assembly. |
|
| SCREW | |
Turn off the projector and disconnect AC plug. Allow the |
|
| ||
1 projector to be cooled for at least 45 minutes. |
|
| LAMP COVER | |
To remove the Lamp cover, remove the screw with a |
| |||
|
| |||
2 screwdriver. |
|
|
| |
Remove 2 screws with a screwdriver and pull out the Lamp |
|
| ||
3 assembly by grasping the handle. |
|
|
| |
Replace the Lamp assembly with a new one and tighten the 2 |
|
| ||
4 screws back into position. Make sure that the Lamp assembly is |
| HANDLE | ||
set properly. Replace the Lamp cover and tighten the screw. |
|
| ||
Connect the AC Power Cord to the projector and turn on the |
| LAMP | ||
5 projector. |
| SCREW | ||
| ASSEMBLY | |||
Reset the Lamp Replace Counter. |
|
|
| |
6 Refer to “Lamp Replace Counter” on the next page . |
|
| SCREW | |
NOTE : Do not reset the Lamp Replace Counter when the |
| |||
|
| |||
Projection lamp is not replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer.
● | Model No. of your projector | : | |
● | Replacement Lamp Type No. | : | |
|
|
| (Service Parts No. 610 302 5933) |
44