Maintenance and Cleaning
Lamp Replacement
When the life of the projection lamp of this projector draws to an end, |
|
the LAMP REPLACE indicator lights yellow. If this indicator lights | Top Control |
yellow, replace the lamp with a new one promptly. |
|
| POWER |
This indicator lights yellow | WARNING |
when the life of the projection |
|
lamp draws to an end. | LAMP |
| |
| REPLACE |
CAUTION
Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp.
1 | Turn off the projector and disconnect the AC plug. Allow the |
| projector to cool for at least 45 minutes. |
2 | Turn over the projector. Loosen the screw with a screwdriver, |
| and remove the lamp cover. |
3 | Loosen 2 screws of the lamp with a screwdriver and pull out the |
| lamp by grasping the handle. |
4 | Replace the lamp with a new one and tighten the 2 screws back |
| into position. Make sure that the lamp is set properly. Replace |
| the lamp cover and tighten the screw. |
5 | Connect the AC power cord to the projector and turn on the |
| projector. |
6 | Reset the Lamp replace counter. |
| See “Lamp Replace Counter” on the next page . |
Screw | Lamp Cover |
Screw
Lamp
Handle
Screw
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● | Model No. of your projector | : | |
● | Replacement Lamp Type No. | : | |
|
|
| (Service Parts No. 610 309 7589) |
45