Sanyo SRT-2400DC SETTING THE CASSETTE EJECT MODE, Cassette Eject Setup, NOTE:, EJECT IN terminal, EJECT OUT terminal, EJECT terminal connection

SETTING THE CASSETTE EJECT MODE

Cassette Eject Setup EJECT terminal connection

When using 2 VCRs or more, the cassette tape of all the VCRs or some of the VCRs can be ejected, if theEJECT terminals on the VCRs are connected as indicated.

1PressMENUthebutton until the (SET UP 4) menu is displayed.

	VCR No. 1		VCR No. 2
	EJECT		EJECT
COM OUT IN		COM OUT IN

@@@@@@@<SET@UP@4>
*SW@OUT
@@TIMING@@@@@@@@@FIELD
@@FIELD@@@@@@@@@@01
@@8H@@@@@@@@@@@@@Y		EJECT IN terminal
*THREAD@CHECK@@@@Y
*VIDEO@LOSS@@@@@@N		• Δεπενδινγ ον τηε (ΣΕΤ ΥΠ 4) ∝ενυ“EJECT
*REC@SPEED@@@@@@@N
*EJECT@SET		MODE” setting (see “Cassette Eject Setup”), the
@@EJECT@MODE@@@@@EJECT1
@@OPERATION@@@@@@SLAVE		cassette loaded in the VCR is ejected when there is
2 Press] thebutton,“EJECTuntilMODE” settingthe
		an input at this terminal.
is flashing.		EJECT OUT terminal
3 Pressl the(orj) button to set the desired cassette
eject mode.		• Ωηεν τηε EJECT button is pressed (if the VCR is
EJECT1 . . . . .		setup as“MASTER”, see step 5 under“Cassette
	The cassette is ejected only if the
		Eject Setup”) or when there is an input (trigger) at
VCR is not in recording mode.
		the EJECT IN terminal, a signal is output at this
EJECT2 . . . . .	The cassette is ejected only		the
		terminal, even if the security lock is set orifa

VCR is in stop mode.cassette is not loaded.

4 Press] thebutton,“OPERATION”until settingtheis flashing.

5 Pressl the(orj) button to set the desired operation.

SLAVE. . . .EJECT. button. Whenis the pressed, the cassette tape of that

VCR only will be ejected.

MASTER . . . . When theEJECT button is pressed, the cassette tape of that VCR and of any VCR connected after it will be ejected.

6 PressPAUSE/SEARCHthe button to save the settings.

NOTE:

•Τηε EJECT button will not be operative during recording mode.

English 37