Sanyo VCC-WB4000 Basic Connections, Connect the camera to a computer, English, Computer

L5AM2/US (VCC-WB4000) GB 2003, 6, 6

Connections

Turn off the power for all equipment before making any connections.

Basic Connections

1 Connect the camera to a computer.

Connect a cable between the ETHERNET connectors of the camera and the computer. Use a crossed wire-type Ethernet cable.

2 Connect the power supply.

After connecting the power supply, install the supplied ferrite core A to the power cord.

•If using a commercially-available 24 V AC adapter, always be sure to connect the ground wire (18AWG or higher) to the ground terminal. (Figure 1)

•If using a 12 V DC power supply (sold separately: DSA-0151CD-12J), make the connections as shown in Figure 2.

Note:

•In order to avoid any problems with the camera and the power supply, take sufficient care to ensure that the polarities are correct when connecting the power supply.

•When the accessory ferrite cores are attached, they will increase the load on the cable, so after doing the installation, adjust the cable accordingly.

3 Insert the power cord plug into a wall outlet.

The POWER indicator B will illuminate.

Computer

						PC CARD
1	3	MONITOR	ETHERNET			RS-232C
		OUT
	B				AC24V	GND
		PC
		POWER 1 2
		MODEM		OUT	DC12VCLASS 2 WIRING
		ALARM IN

Ethernet cable

(crossed wire-type cable)

A

24 V AC connection 12 V DC connection

AC24V

DC12V

2

Figure 1

GND AC24V GND

DC12V

2

Figure 2

English – 9 –