Eurocharacter Select

Command Structure <ESC>LD,a,b,c,d,e,f,g,h,i,j,
a = Replacement character for STX in ASCII or hex format
b = Replacement character for ETX in ASCII or hex format
c = Replacement character for ESC in ASCII or hex format
d = Replacement character for ENQ in ASCII or hex format
e = Replacement character for CAN in ASCII or hex format
f = Replacement character for NULL in ASCII or hex format
g = Replacement character for OFFLINE in ASCII or hex format
h = Auto-Online. Printer powers up in the On Line mode.
0 = Yes
1 = No
i = Zero Slash. Places a slash through the “0” character.
0 = Yes
1 = No
j = Eurocharacter select. Hexadecimal code for character to be
replaced by the Eurocode character
Example: <ESC>LD,{,},%,#,&,*,~,0,0,D5
Placement: Immediately following the <ESC>A Start command and in
an independent data stream.
Default: Standard Protocol command Codes
Command Function Allows the user to defines custom Protocol Command codes.
Printer Input <ESC>A
<ESC>LD,{,},%,#,&,*,~,0,0
<ESC>Z
Printer Output A Protocol Command code status label will be printed as a result of
the a successful download of a custom set of Protocol Command
codes.
Special Notes 1. The parameter values can be left out if a change is not desired,
however the commas must be present, i.e. to select D5H as the
Eurocharacter without changing anything else, the command
would be <ESC>LD, ,,,,,,,,D5 (9commas).
Not
Implemented
Section 4. Programming Reference
Page 4-829001069A SATOCTSeriesPrinters