SATO 410, 400 manual Cleaning the Sensors, Supplies Needed Sato SA070 Cleaning Kit

Section 3: Cleaning and Maintenance

CLEANING THE SENSORS

There are two sensors that are used to control the positioning of the label. One is a transmissive see-thru sensor that detects the edge of the label by looking through the backing paper which is translucent and detecting the presence of the opaque label. The other is a reflective sensor that detects the light reflected from the bottom of the label liner. When a printed black Eye-Mark passes through the beam, the light is no longer reflected back to the sensor detector, indicating to the printer that it should use this position as the start of a new label. When dust, dirt or other foreign matter interferes with the light path of either of these sensors, the results is erratic label positioning. These sensors should be cleaned regularly, at least every two rolls of labels.

Supplies Needed: SATO SA070 Cleaning Kit

1.Turn the printer off and remove the power cable.

2.Open the Top Cover.

3.Open the Print Head Assembly by pushing the Head Latch toward the rear of the printer. The Print Head Assembly is spring-loaded and will automatically open as soon as the Head Latch is disengaged. The sensors are built into the left hand Label Guide so that they move whenever the Label Guides are adjusted for different media widths.

4.Apply SATO Thermal Print Head Cleaner to one of the cotton swabs.

5.Use the cotton swab to clean any foreign matter from the exposed surface of the sensors by inserting the cotton tip in the paper slot and brisky cleaning it with a back and forth motion.

SATO CT Series Printers 9001069A Page 3-5