Quick Dial
57
3
DSelect the standard message to
be stamped at the second or
third line.
EPress [OK].
FPress [OK].
GPress [OK].
Note
If you press [Cancel], group is
not programed. The display ap-
pears as in step C.
HPress [Exit] twice.
The machine will return to standby
mode.

Editing Quick Dials

Change the receiver information al-
ready programed.
Limitation
When a programed Quick Dial key
is being used for a standby Memo-
ry Transmission, the message
"Specified destination is
used by transmission standby
file. It cannot be changed or
deleted. Specify it again
after transmission is com-
pleted." is shown. You cannot
change the destination for this key.
APress [Dest. Management].
BSelect [Program/Change/Delete Quick
Dial].
AdonisC2_EN_b-f_FM.book Page 57 Tuesday, J anuary 23, 2001 4:45 PM