Schneider Electric PWRSRV710, PWRSRV750 setup guide Calibrating The Touch Screen, Care And Cleaning

Appendix G—POWERLOGIC System Display (SD700) Installation	63230-216-207/A3
Calibrating the Touch Screen	9/2002

3.Connect the female end of the serial cable to the COM 2 serial port on the Power Server (see Figure G–2). Tighten the captive screws on the cable connector.

4.Connect the male end of the serial cable to the Touch Screen Serial Output port on the system display. Tighten the captive screws on the cable connector.

5.Locate the video cable supplied with the system display.

6.Connect one end of the video cable to the female Video input port on the side of the system display. Tighten the captive screws on the cable connector.

7.Connect the other end of the video cable to the VGA output port on the Power Server (see Figure G–2). Tighten the captive screws on the cable connector.

COM 2 serial port — connect to

VGA output port — connect

the touch screen output port on

to the VIDEO input port on

the system display.

the system display.

		COM2
	Figure G–2: Power Server connectors
CALIBRATING THE TOUCH SCREEN	The first time you power up the system display, you should calibrate the
	touch screen.
	To calibrate the touch screen, do the following:
	1.	Ensure that the Power Server is running and that the Power Server
		interface is visible on the monitor.
	2.	Touch the Maintenance tab.
	3.	On the Maintenance tab, touch the Calibration button.
	4.	Follow the on-screen instructions.
	5.	When calibration is complete, touch the screen in several places and
		ensure that the pointer arrow accurately follows your touch. If it does not,
		repeat the calibration procedure.
CARE AND CLEANING	Occasionally clean the display panel with a soft cloth dampened with glass
	cleaner. Spray cleaner on the cloth. Do not spray cleaner directly on the
	touchscreen. Keep turning a fresh side of the cloth toward the screen surface
	to avoid scratching it with accumulated grit. Allow the screen to air dry.

NOTE: Never use ammonia-based cleaners to clean the touchscreen. Do not use paper products to clean the screen as they may scratch the surface.

54 © 2002 Schneider Electric All Rights Reserved