Schneider Electric PWRSRV750 Table C-1 Power Server Setup-HyperTerminal Options, desktop

63230-216-207/A3	Appendix C—Using a Crossover Cable to Configure the Power Server
9/2002

14.After you have connected to the Power Server via NetMeeting, press Ctrl-Won your keyboard to switch to the Power Server desktop.

15. Double click the Network Setup icon	on the Power Server
desktop.

NOTE: Even if the Power Server will not be used in a networked environment, you must run the Network Setup application at least once and then type 5 to quit.

16.Set all of the network setup options as described in Table C–1 on page 37.

NOTE: To change any of the options, type the option number at the Enter Option prompt and press Enter.

17.Follow the onscreen instructions to change the value.

Table C–1: Power Server Setup—HyperTerminal Options

Option	Description
	The computer name defaults to the MAC Address. We
	recommend that you leave the default computer name. If
Computer Name	you must change the name, it must be a unique alpha-
	numeric name, limited to 15 characters, no spaces or
	special characters.
IP Address 1	Use IP Address 1 as the primary address to access all the
	capabilities of the Power Server.
Subnet Mask 1
	Subnet Mask 1 is assigned to IP Address 1.
IP Address 2	IP Address 2 and Subnet Mask 2 are optional. They should
	only be used if slave Modbus/Jbus and POWERLOGIC
Subnet Mask 2
	devices need to have the same address on both COM 3 and
(optional)
	COM 4.
Router Address	Address of your company’s Ethernet LAN router, if
	applicable.
MAC Address	Unique media access control number (cannot be changed).

© 2002 Schneider Electric All Rights Reserved 37