ST1.3 Series Product Manual, Rev. C 21
3.0 Configuring and mounting the drive
This section contains the specifications and instructions for configuring and mounting the drive.

3.1 Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis-
charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

• Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s
exposure to ESD.
• Before handling the drives, put on a grounded wrist strap, or ground yourself frequently by touching the metal
chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire
installation procedure.
• Handle the drive only by its edges or frame.
Figure 7.ST
1.3 Series
proper
handling example
• The drive is fragile—handle it with care. Do not press down
on the drive top cover or attempt to use a pen to write on
the drive’s label.
• Do not apply more than 0.2 kg of force to the top cover.
Drive HDA Cover
Drive Base Plate
Host PCB
Mounting
Bend Radius
Corners Drive ZIF Connector
Host ZIF Connector
Rubber to be at least
1mm thick. For better
shock protection,
thicker rubber is
better.