b. Before tightening fence lock knob, hold fence
down on outfeed table so it does not rock.
c. 90 ° Fence Stop positions fence square to tables. To tilt fence, loosen the two knobs and pull the stop out. Tilt to desired angle and tighten both knobs.
d. To set fence at 90 ° to tables, loosen the two
knobs, tilt fence so the stop springs back ifito place. Tilt fence back so the stop rests on the
,1
3.FENCE TILT SCALE. Indicates the angle of the fence to the tables. When the 90 ° fence stop is cor-
rectly adjusted, the fence will be 90 ° to the table and the scale wil! read 90 °,
To check for squareness, place an accurate square on infeed table and check fence while locked at 90 °
position. MAKE SURE 90 ° STOP IS AGAINST
table and tighten both knobs.
e. 45 ° Fence Stop positions the fence at 45 ° to the tables.
f. To tilt fence to 45 ° loosen the two knobs, pufl 90 ° stop out, tilt fence so the 45 ° stop rests on the tab{e
g. Hold fence down on outfeed table and tighten the two knobs.
SQUARE tNFEED
SLIDE BRACKET.
If fence is not square to table;
a. Slightly loosen fence lock knob and guard lock knob.
FENCE FACE
TABLE
b, Loosen 90 ° stop screw with small screwdriver and turn knurled sleeve which will cause fence to tilt.
Turn sleeve in either direction until fence is square with infeed table.
NOTE: If you cannot square fence by turning knurled sleeve, loosen three screws "A" and adjust fence square to table.
c_ Tighten 90 ° stop Iockscrew and both fence lock knobs,
d. If 90 ° reading on tilt scale does not line up with top surface of the slide bracket, loosen screws
holding scale and move _t . , . tighten screws.
CUTTER
GUARD
| SCALE |
| ADJUSTING |
| SCREW |
| LOCKSCREW |
, | SCALE |
| . TILT |
k" 90 ° STOP |
450 | STO_ |
|
KNURLED | _'_ | BRACKET |
13
