;i

a, Insert a pencit in space at end of cutterhead to

hold cutterguard open,

b, Place a straightedge (large square or tong level) on outfeed table, First along one side than along the other,

c, Raise infeed table until it touches straightedge.

d, Sight between table and straightedge to determine

high or low condition of end of infeed table.

It is easier to adjust the infeed table while the Jointer is setting on your workbench.

Do not turn the Jointer on its side or upside down to adjust it.

Attach a strip of wood to two blocks of wood 10 in. high. Drive enough nails into the strip so that Jointer does not tip over while resting on blocks.

a. Remove motor cord from outlet in switch box.

b, Remove Jointer pulley guard andV-belt.

c. Remove Jointer from stand,

d. Lower the infeed table,

e, Place Jointer on btocks.

,,,,u ,,

f, Insert a peneit in space at end of cutterhead to

hold cutterguard open,

g. Wrap a piece of cardboard around cutterhead to protect your fingers and the blades . . . secure cardboard with a piece of tape,

!/:i! !¸:i_:_

ROTATE

BLADE OUT OF

WAY

PENC L

OUTFEED

TABLE

10 IN,

OF WOOD

YOUR WORK

BENCH

15

Page 15
Image 15
Sears 206801, 113.206931 manual Rotate Blade OUT WAY Penc L, Wood Your Work Bench, Outfeed