The normal |
|
|
|
|
| when | fence | is | ||||
stationed at MAXt |
|
|
|
|
|
|
|
|
| |||
"pOsition | "A" | NEVER |
| ROTATE |
| E |
|
| EX |
| ||
P | OStTION | .... | BECAUSE | THIS | WOULD | XERT | - | |||||
| B |
|
|
| ||||||||
CESSIVE | TENSION | ON | :SPRING WHICH |
| COULD |
|
| |||||
WEAKEN | OR | BREAK |
| IT. |
|
|
|
|
|
|
| |
|
|
| gUARD and | SPRING. |
|
|
|
|
| POSITION "A" | ||
|
|
|
|
|
|
|
|
| ||||
I. With fence in MAXIMUM WIDTH OF CUT position, pass a piece of 1/4 in, thick wood on edge (jointing position) over cutterhead.
2, The guard should return automaticall_ to its REST
position against the fence when free of the wood.
3, If guard does not return to its REST position, remove cotter pin from pivot pin and remove guard, Check
pivot pin and hole.., make sure there are no burrs, rust, or other foreign matter.
4, Apply a. few drops of SAE No. 20 or No, 30 engine
oil to pivot pin,
5. Replace guard and cotter pin.
If guard still does not return to its REST position; con-
sult your local Sears Retail Store before using the
WIDTH OF
CUT
SHARPENING CUTTER BLADES
The blades can be honed individually with an ordinary oilstone.
Make sure your oilstone is not worn in the center. It must be flat.
Be sure to remove the burr on the flat side.
If the blades are nicked, they must be replaced or re-
ground, They can be reground several times until they become 91t6 in. wide. Never install reground blades less than 9/16 in. wide.
Have your knives reground by someone who is com-
petent. Look in the "Yellow Pages" of your telephone directOry.., see "Sharpening Services".
11/16 IN.
NEW BLADE
24
