CARE AND CLEANING
For best performance and safety, keep the oven ctean inside and outside. Take spec a[ care to keep the inner door panel and the oven front frame free of food or grease
Never ese rough powder or pads, Wipe the microwave oven inside and out, including the hoed bottom cover, with a soft cloth and a warm(not hot) mild detergent solution. Then rinse and wipe dry. Use a chrome clearer and polish on chrome, meta_ and aluminum surfaces. Wipe spatters immediately with a wet paper towel, especially after cooking chicken or
bacon. Ciean your OVeR weekly or more often, if needed.
TEMPERATURE PROSE
Remove the temperature probe from the socket after each use. Ctean the probe with a mild detergent solution. C_eanthe sensor with a soft, damp ctoth, Use a pot holder because rife wire_ plug, and sensor sections may be hot,
METAL RACK
Wash the metal rack with a mild soap and a soft or
nylon scrub brush.Dry completely.
Do not use abrasive scrubbers or cleaners to clean rack.
3.To reinstall the fitters slide it into the side sfet_ then push up and toward oven center to look.
i
NOTE: Do not operate the hood without the filters in ptace_
CHARCOAL F_LTER REPLACEMENT
If your oven is vented inside, the charcoal filter (part #507269) should be replaced every 6 to I2 months, and more often if necessary. The charcoal filter cannot be c_eaned. To order a new charcoal finer, contact the
Parts Department at your nearest Sears Store or Service Center,
t. Remove the two vent griLte mount{rig sctews (2 middle screws)
CLEANING THE GREASE RLTERS
1.To remove grease filters_ slide each fitter to the side. Pull filters downward
and push to the other side. The fitter will drop out.
2.Tip the gril}e forward then iift it out
3.Remove old filter.
'_
7
2Se_k grease filters in, hot water and a miid detergent. Rinse wen and shake to dry. Do not use ammonia or place in a dishwasher. The afuminum will darken,
4.Slide a new charcoai filter intoplace. The filter should rest at the angle shown.
5.Slide the top of the vent cover into place. Push the bottom until it snaps into place, Replace the mounting screws. Turn the power back on at the main power suppty.
- 27