2. Slide the Front Upright (42) onto the 5/16” x |
2 1/2” Carriage Bolts (1) in the Base (4). Hand |
tighten a 5/16” Nylon Locknut (3) onto each |
Carriage Bolt. Do not tighten the Nylon |
Locknuts yet. |
Press a 1” Square Inner Cap (65) into the |
Front Upright (42). |
Press 1” Round Inner Cap (49) into each end |
of the Footrest (83). Attach the Footrest to the |
Rear Upright (56) with a 5/16” x 2 3/4” Bolt |
(11), two 5/16” Flat Washers (8), a 1/2” x 1/2” |
2
56
Bushing (87), and a 5/16” Nylon Locknut (3). |
8
42
FRAME ASSEMBLY
3. Press a 2” Square Inner Cap (27) into the indi-
cated end of the Top Frame (55). Press a 1 3/4” Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press two 1” Round Inner Caps (49) into the top of the crossbar.
Attach the Top Frame (55) to the Front Upright
(42)and the Rear Upright (56) with four 5/16” x 2 3/4” Bolts (11), four 5/16” Flat Washers (8), and four 5/16” Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 1 through 3.
4.Set two Weight Bumpers (19) on the indicated bracket on the Base (4) as shown.
Stack eight Weights (25) on the Weight Bumpers (19). Be sure that all of the
Weights are turned so the deepest pin grooves are under the Weights and are on the indicated side.
49 | 3 |
87 | 83 |
65
11 | 8 | 3 |
| ||
|
|
49 |
4
1
3 |
| 11 |
|
|
| 27 | 8 | 11 |
|
| 8 49 |
| ||
|
| 44 | ||
|
|
|
55 |
56 44 | Crossbar |
| 42 |
3 |
3
4
25 
Pin
Grooves
19
4
6
