29. Press a 1 1/2” Square Inner Cap (32) into the |
Seat Frame (36). |
Insert the 1/4” x 2” Carriage Bolt (38) into the |
center hole in the Seat Plate (37). Attach the |
Seat Plate to the Seat (13) with two 1/4” x |
1/2” Screws (18). |
Insert the 1/4” x 2” Carriage Bolt (38) into the |
indicated hole in the Seat Frame (36). |
Tighten a 1/4” Nylon Locknut (2) with a 1/4” |
Flat Washer (10) onto the Carriage Bolt. |
Attach the other end of the Seat (13) to the |
Seat Frame (36) with a 1/4” Flat Washer (10) |
and a 1/4” x 2” Screw (24). |
30. Lubricate the 5/16” x 2 1/4” Bolt (33). Attach |
the Leg Lever (29) to the Seat Frame (36) |
with the 5/16” x 2 1/4” Bolt and a 5/16” Nylon |
29
13
38 |
37 |
18 |
36 | 32 |
24 10 2
30
36
Locknut (3). |
33
Lubricate
3
SEAT ASSEMBLY
31.Attach the Short Cable (35) to one of the three holes in the Leg Lever (29) with a 5/16” x 3/4” Bolt (89), a 5/16” Washer (8), and a 5/16” Nylon Locknut (3). Note: The three holes are for cable adjustment. Insert the Short Cable between the welded rod and the Leg Lever.
Press a 1” Round Inner Cap (49) into each end of the Curl Bar (86). Slide the 1/2” x 3/8” Bushing (91), the Curl Bar, and the Short Cable (35) onto the 5/16” x 1 1/4” Carriage Bolt (90). Hand tighten a 5/16” Nylon Locknut
(3)onto the Carriage Bolt.
32.Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat Frame to the Front Upright with a 5/16” x
2 3/4” Carriage Bolt (14) and the Seat Knob
29
31
| 29 |
|
89 |
|
|
8 |
|
|
3 |
| 49 |
Welded Rod |
| |
|
| |
3 | 35 | 91 |
|
| |
49 | 86 | 90 |
32 |
|
40 | 36 |
14 |
Pin |
42 |
14
