PROBLEM: The walking belt is off-center when walked on
SOLUTION: a. If the walking belt has shifted to the left, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left adjustment bolt clock- wise 1/4 of a turn. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.
a |
b. If the walking belt has shifted to the right, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left adjustment bolt counter- clockwise 1/4 of a turn. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.
b |
PROBLEM: The heart rate monitor does not function properly
SOLUTION: a. If the heart rate monitor does not function properly, refer to HEART RATE MONITOR TROUBLE- SHOOTING on page 6.
b. The CR 2032 battery may need to be replaced.
If the heart rate monitor still does not function properly, the battery should be changed. To replace the battery, locate the battery cover on the back of the sensor unit. Insert a coin into the slot in the cover and turn the cover counterclockwise to the ÒopenÓ position. Remove the cover.
Remove the old battery from the sensor unit. Insert a new CR 2032 |
|
|
|
|
|
|
|
| |
battery, making sure that the writing is on top. In addition, make sure |
|
|
|
|
that the rubber gasket is in place in the sensor unit. Replace the bat- |
|
|
|
|
tery cover and turn it to the closed position. |
|
|
|
|
| Battery |
|
| |
|
|
|
| |
|
|
|
| |
|
| Rubber | ||
|
| Gasket |
| |
|
|
|
|
|
|
|
|
|
|
PROBLEM: An error code (E1, E20, E21, E22, E23, OR E24) appears on the console
SOLUTION: a. If an error code appears, remove the key from the console, wait for a moment, and then reinsert it. If the error code appears again, call our Customer Service Department. Do not use the tread- mill until the problem is corrected.
19
