OVENCONTROL,CLOCKand KITCHENTIMERcontinued
Your new control has a series of tones that will
sound at different times These tones may sound while you set the control for an oven function, or at the end of the oven function It will also alert you there may be a problem with
the functions Below are the types of tones and a brief description of each
TONES WHILE SETTING THE
CONTROL
When you press a touch pad you will hear a
beep This beep will let you know you have
placed enough pressure on the pad to activate it
END OF TIMED CYCLE TONE
At the end of a timed cooking function, you will hear 3 short beeps followed by I beep every
6 seconds This 6 second beep will continue
to sound until the CL£4R/OFF pad is pressed or you may select the special feature to cancel this 6 second beep from sounding at the end of future cycles
TO CANCEL THE 6 SECOND BEEP
1.Press and hold the BAKE and BROIL
pads, at the same time, until the display shows "SF'o
2.Press the KITCHEN TIMER ON/OFF pad The display will show "CON BEEP" (continous beep)
3.Press the KITCHEN TIMER ON/OFF pad again The display will show"BEEP" (beep canceled)
4.Press the START pad
if you would like to return the 6 second beep, repeat steps above until the display shows your choice and press start
ATTENTION TONE
This tone will sound if you make an error or an
oversight is made while setting an oven function
Examples would be:
a.Setting a clean cycle and the oven door is not closed properly
b.Setting a timed function and the time being set is invalid
c.Pressing an additional function pad without first setting a temperature or time
Any of these can be quickly identified by watching the display
PRENEA T TONE
When you set an oven temperature, the oven
automatically starts to heal When the
temperature inside the oven reaches the temperature you have set, a tone will sound to let you know the oven is ready for baking
If you set an oven function and the control beeps while the display is flashing "F" and a number "F.4" or letter "FI" there may be a
problem with the control Simply press the CLEAR/OFF pad and wait about an hour Try setting the function again ff the code repeats, write down the flashing code and carl for service Tell the technician what the code was flashing
9
