IMPORTANTINSTRUCTIONSFOR YOURSAFETY
Tools you will need:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
1.Remove the bracket from the prepack located inside the oven.
2, Decidewhetherthebracketwillbeinstalled
on the right or left side of range location.
3, ff the bracket side of the range is adjacent
to a cabinet, place the bracket against back wall and cabinet as shown below.
ADJACENT CABINET OR FINAL |
| |
LOCATION OF RANGE SIDE | OUTS_OEEDGE OF | |
PANEL | ||
TO BE | ||
| ||
| FLUSH WITH LEFT OR | |
| RIGHT SlOE OF RANGE | |
| \ | |
| WALL BEHIND | |
| RANGE1 |
If there is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Place the bracket with its outside edge at this location and against back wall. See illustration below.
o Determine whether you will anchor the bracket to the floor or wall. Make sure this
location is clear of electrical wiring or plumbing.
5.Fasten the bracket securely with the screws
provided. Screws are
most metal framing. If attaching to masonry, you can buy suitable screws and
anchorsathardwarestores. Useamasonry drill to drill the required holes.
BRACKET | WALL | |
\ | ||
PLATE |
SCREW MUST ENTER _k | / |
| |
WOOD OR METAL |
|
ATTACHMENT TO WALL
6.Using the wrench, back out the four leg levelers at least two turns. See your
installation guide for more leveling information before positioning range.
7.Slide the range in to place. Be sure rear leg
levelerfuIlyengagestheslotinthebracket. If
range cannot be moved back far enough for rear leg leveler to enter bracket, move
bracket forward as required and attach to floor in new location.
3
